10X
101: Interrupt failure
102: Clock failure
103: time interrupt failure
104: Protected mode failure
105: Last 8042 command not accepted
107: NMI test failure
108: Clock bus test failure
109: Low meg-chip select test system board. Nm
110 memory slots memory parity detection plane if connected to a computer system motherboard to remove the extension parts
111I / O expansion memory parity detection system motherboard components or port replicator.
11XX
1101: A class of device failure detection system board serial device communication wiring
12XX
1201: B type detection failed system board (infrared)
158 is set SuperVisor password, but not set hard drive password set password
159 hard drive password and the password is not the same set SuperVisor hard disk password and the password the same SuperVisor
161 battery backup battery backup battery failure detection system board.
Time and date is not set 163 to set the time and date system board.
173 equipment, loss of data on the screen, select OK, and then set the time and date of backup battery system board.
174 set error: first, testing installed equipment list and then change the FRU parts hard drive detection device configuration system board.
0175 CRC1 wrong, stop POST task. EEPROM checksum error. System board security chip
0177 SuperVisor password wrong system board test
0178EEPROM system board failure
2010 hard drive microcode
17XX
1701: hard disk controller failure
1780, 1790: Hard Disk 0 Error
1781, 1791: Hard one error hard disk drive system motherboard
183 SuperVisor password when prompted enter the wrong password to enter the correct SuperVisor
184 power-on password to enter BIOS settings wrong test to reset the boot password
185 illegal, access to BIOS settings, boot sequence reset the boot sequence
1861 System board
0187 EAIA data read errors. EEPROM read failure. System board
0188 RFID illegal CRC2 wrong region or continuous information. EEPROM checksum error. System board
0189 illegal RFID continuous information area. EEPROM checksum error. System board
0190 battery low error to charge the battery the battery compartment
0193 RF antenna was removed. Input supervisor (Super) Password
0194 notebook is carried through the security inspection gate input supervisor (Super) Password
0195 security hardware security disturbance input SuperVisor (super) password to access the BIOS setup utility, select Config, select the IBM Security Chip, select ClearIBM Security Chip to clear this error System board security chip
0196 Security hardware removed the safety input SuperVisor (super) password to access the BIOS setup utility, select Config, select the IBM Security Chip, select Clear IBM Security Chip to clear this error System board security chip
0197 Illegal modify the requirements of remote remote configuration of the security failure of the security chip. To confirm the operation and try again.
01C8 multiple Modem device - removal of one of press Esc to continue. Removed a MiniPCI Modem card or Modem daughter card, or press Esc to ignore the error.
Mainboard
01C9 multiple network class device - removal of one of press Esc to continue. Removed a MiniPCI Ethernet card or Ethernet daughter card, or press Esc to ignore the error.
Mainboard
0200 hard disk error. The hard non-work. Re-install the hard disk (demolition) in the BIOS setup utility to restore the default setting hard disk drive system motherboard
021x Keyboard error running interactive keyboard and auxiliary input device testing
0220 Monitor type error. Monitor type does not match with the CMOS definition. In the BIOS setup utility to restore the default settings
0230 map of memory error. Memory mapping error in the offset nnnn. System board
0231 system memory error. System memory error in the offset nnnn. Motherboard memory system
0232 expanded memory wrong. Extended memory error in the offset nnnn. Memory. System board
0250 System battery error - System battery damage replacement battery backup, running IBM BIOS setup utility to reset the date and time.
0251 System CMOS checksum error - default settings using the replacement battery backup, running IBM BIOS setup utility to reset the date and time.
0252 Password checksum error - password is cleared to enter IBM BIOS settings and clear the password (Reset)
0260 replacement battery backup system time error, run IBM BIOS setup utility to reset the date and time.
Mainboard
0270 real-time clock wrong replacement battery backup, running IBM BIOS setup utility to reset the date and time. Mainboard
0271 date and time wrong. Computer has not set a date or time. Run IBM BIOS setup utility to reset the date and time
0280 Start incomplete error - The default setting to use into the IBM BIOS setup utility to restore defaults memory. System board
02B2 Incorrect drive A disk drive
External floppy disk drive
I / O card
02F4 EISA CMOS not write into the IBM BIOS setup utility to restore the default settings replace the backup battery system motherboard
Memory test failed 02F5 memory. System board
Software NMI failed 02F6 memory. System board
02F7 Fail-safe timer NMI failure of memory. System board
1801 connected to the docking station does not support Turn off the computer and then remove it
1802 unauthorized network card inserted - and then remove the miniPCI network card installed remove the miniPCI network card. System board
Device address conflict: Device address conflict
In the BIOS setup utility to restore the default settings backup battery system motherboard
Allocation error for device: equipment positioning error
In the BIOS setup utility to restore the default settings backup battery system motherboard
Failing bits: nnnn-bit failure
System board DIMM memory slots
Invalid system configuration data: illegal, system configuration data
System board DIMM memory slots
I / O device IRQ conflict: I / O device IRQ conflict
In the BIOS setup utility to restore the default settings backup battery system motherboard
Operating system not found: no operating system
Check operating system error and is not installed correctly. Enter the IBM BIOS setup utility checks the hard disk or floppy drive is recognized correctly
Reset hard drive to reinstall the operating system hard disk drive floppy disk drive system motherboard
Hibernation error: hibernate error
Restore system settings to enter sleep state if the memory capacity before replacement, and re-create the hibernation file (delete c: hibernation file the following re-entry)
Fan error: Fan Error
Fan
Thermal sensing error: thermal sensor error
Mainboard
1. Select OK in the error screen; then set the time and date.
(ERROR in the boot screen, press OK, and then set the system time)
2. Backup battery. (CMOS battery needs to be replaced)
3. System board. (Motherboard problem)
163 (Time and date were not set.) (System time has not set a good or confusion)
1. Set time and date. (To set the correct system time)
2. System board. (Motherboard problem)
192 (Fan error.) (CPU cooling fan failure)
1. Measure the voltage of the backup battery. If the
voltage is not correct, replace the backup battery.
(Check the CMOS backup battery voltage, replace the battery voltage not work)
2. Fan (to replace the CPU fan)
3. System board (motherboard problem)
没有评论:
发表评论